New Products

New generation sealant tape for high temperature applications. Fast Tack HT builds tack quickly when applied to Thermalimide. Having good room temperature adhesion to the high temp bagging film reduces the time required to vacuum bag high temperature parts.

LTC3 prepregs offer a low temperature cure and high temperature use after post cure. LTC prepregs allow the use of lower cost master model materials.

Blueflow 88 is designed to efficiently distribute resin with little waste due to the low profile, tight construction. Blueflow 88 can be used with polyester, vinylester and epoxy resin systems. Wide widths available in 1.5 m (60 inches) and 2 m (80 inches).

A4000 LFST is a heat shrinkable lay-flat tube which has been oriented in the transverse direction. When exposed to heat 249 to 348°F (121 to 176°C) in a recirculating oven, tunnel oven or from a heat gun, the A4000 LFST material will shrink to closely fit the mandrel.

Airtac 3 is a new, safer spray adhesive designed for temporary bonding. Airtac 3 can be used to hold dry materials on contours and vertical surfaces. This product is ideally suited to resin infusion applications for holding reinforcement plies, release films, peel plies, and infusion mesh in place until the vacuum bag is secured. Airtac 3 has a fine pebble spray pattern which reduces airborne material. This reduces overspray and user exposure. Air trigger is sold separately.

Combo-Tech is our expanded product line that bonds various vacuum bagging materials together to form a better overall product and reduce “touch labor”, saving companies hours of labor expense while increasing productivity.

Filmcote® 1524 is an engineered film developed as a replacement for release liquids on the surface of mold tools. Filmcote® 1524 remains on the part surface after demold providing protection from damage or contamination during subsequent process.

GS-333LT is a low tack version of our standard GS-333 tape. GS-333LT is a sealant tape which has been designed to take longer cures and still remove cleanly.

Airweave® UHT 300PGL and Airweave® UHT 450PGL are premium non-woven blended, fiberglass breather for ultra high temperature applications. It is safer to use these breathers in place of woven fiberglass breathers.

Flashbreaker® 1R is now available in 1” x 2” (2.54 cm x 5.08 cm) Pre-Cut Tape Strips for customers who want to reduce touch labor and minimize the use of knives and scissors to avoid risk of hand injury. In addition, it eliminates the possibility of damaging the vacuum bag. There’s 2,500 cut strips per roll.